GE Profile PHS925ST1SS - Page 58

– 58 –
(Continued next page)
To remove the oven door lock assembly on
PSH925:
1. Disconnect power to the range.
2. Open the oven door. (See Oven Door Assembly.)
3. Remove the cooktop. (See Cooktop Assembly.)
4. Remove the two 1/4-in. hex-head screws that
attach the oven door lock assembly to the front
of the mounting plate.
5. Pull the oven door lock assembly toward the
rear of the range.
Caution: It is possible to reconnect the switch wiring
incorrectly to the lock assembly. In the following
step, when disconnecting the wiring, make a note of
how the wires are connected.
6. Remove the 3 wire harnesses from the oven
door lock assembly.
Disconnect
Disconnect
Disconnect
Door Locked-PS978
Door Unlocked-PS978
Hook Pulled In - Top Switch Closed -Bottom Switch Open
Hook Pushed Out - Top Switch Open - Bottom Switch Closed
BU
O
Y
Y
O
BU
Lower
Lock
Switches
Upper
Lock
Switches
2
3
4
5
6
7
RPSM
J16
BU
O
Y
Y
O
BU
Lower
Lock
Switches
Upper
Lock
Switches
2
3
4
5
6
7
RPSM
J16