ā 77 ā
The F-Code log can be erased by pressing 9 and 0 together while the log is being displayed.
Note: Only the log displayed is erased/cleared.
Press C
LEAR/OFF to exit the F-Code mode and return to the time of day display.
Bad Line Display
A bAd LinE will be displayed to signal a terminal block cord miswire. It will appear if 120 VAC is not present
between J21-5 and J20-3. It will also appear if there is less than 200 VAC between J20-1 and J20-3. J20 and
J21 are both located on the RPSM Board.
(Continued next page)
UPPER
----
---
11:24
bAd LinE
To Next Page
Loading...
