– 80 –
Key Displayed for 10 Seconds Test Performed
START tESt Convection Fan ON (CW)
Bake tESt Bake Element On With DLB
Conv tESt Convection Element On With DLB
Probe Probe Temperature (when plugged in) Probe Temperature
Broil tESt Broil Element On With DLB
Clean Door Status Locks, then Unlocks The Door
Cook Time Oven Sensor Temperature and ROM Version
Delay Start Model ID and EEPROM Checksum Convection Fan On (CCW)
Oven Light tESt Oven Light On
Clock All Wing-L and Wing-R LEDs ON Operates All Wing-L and Wing-R LEDs
Timer ON 10 digits and all LEDs In Display
Timer Off All white key LEDs (except Clear/Off)
10 KEY 3 AC Input Voltage from RPSM J20 L1 to L2 Voltage at RPSM J20 Shown
10 KEY 5 Beep Volume Level Hi-Std-Lo Sounds Beep Volume Levels
RF ON/OFF RF - segment - Segment, Element ON, Hot Cooktop RF LED ON
RF - RF - L L Digit ON
RF + RF - H H Digit ON
RF Power Boil * ½ segment ½ segment ON
RR ON/OFF RR - - Segment ON
RR - RR - L L Digit ON, Hot Cooktop RR LED ON
RR + RR - H H Digit ON
LF ON/OFF LF - segment - Segment ON, Hot Cooktop LF LED ON
LF - LF - L L Digit ON
LF + LF - H H Digit ON
LF Simmer * ½ segment in LF digit ½ segment ON
LR ON/OFF LR - segment - Segment ON
LR - LR - L L Digit ON, Hot Cooktop LR LED ON
LR + LR - H H Digit ON, 4 Hot Cooktop LEDs ON
LR Simmer ** ½ segment in LR digit ½ segment ON
RR Melt ½ segment in RR digit ½ segment ON
WZ ON/OFF WZ
..
segment in WZ digit WZ
..
segment ON
WZ Select M in WZ digit M Digit ON
10 Key 7 tESt Blower ON
Test Mode
To enter the test mode, disconnect power to the range for 5 seconds, reconnect power, and then press
keys 1 and 5. The display will show tESt. A test feature is selected by pressing certain individual keys. When
selected, each test feature will remain displayed for 10 seconds, and then the display will return to tESt. To
exit the test mode, touch the Clear Off pad. The test mode will automatically time out in 10 minutes.
(Continued next page)
* Burner Size on PS978
** Melt on PS978
To Next Page
Loading...
