– 25 –
Components
Freezer Evaporator
The following components must be removed in the
appropriate order to access the freezer evaporator:
Unplug the refrigerator.
Remove the ice bucket, shelves, and drawers.
Using a small fl at-blade screwdriver, expand
the 2 clips and disconnect the icemaker wire
harness from the auger motor assembly.
1.
2.
3.
Note: The icemaker is held to the left side freezer
wall with a Phillips-head screw, spacer, and 2 posts.
Remove the single Phillips-head screw from the
icemaker.
4.
Rotate the icemaker to the right, then pull the
left side towards the front to disengage it from
the 2 posts.
5.
Clip (1 of 2)
Icemaker Wire Harness
Post
Post
Spacer
Remove the four ¼-in. hex-head screws from
the front of the auger motor assembly.
6.
Lift the auger motor assembly up, pull it forward,
and disconnect the wire harness.
7.
Remove the four ¼-in. hex-head screws
that attach the QuickFreeze
™ fan housing (if
equipped), to the 2 mounting brackets.
8.
Wire Harness
(Continued next page)
To Next Page
Loading...
