To Next PageTo Next PageWhy is there water remaining on the oven floor after Steam Clean cycle of GE PSS93 Ranges?
It is normal to have water remaining on the oven floor after a Steam Clean cycle. Remove any remaining water with a dry cloth or sponge.
Why my GE PSS93 oven does not work?
If your GE Ranges oven isn't working, make sure the range is completely plugged into a properly grounded electrical outlet. Check your home's fuse or circuit breaker and replace or reset if necessary. Verify the oven controls are correctly set and ensure the oven isn't in Sabbath Mode.
Why won't my GE PSS93 Ranges oven steam clean?
If your GE Ranges oven won't steam clean, and the display flashes HOT, allow the oven to cool to room temperature and reset the controls. Ensure the oven controls are set correctly by referring to the Using Steam Clean section. Also, make sure the oven door is fully closed to start the steam clean cycle.
Why does my GE Ranges oven sometimes take longer to preheat?
Your GE Ranges oven might take longer to preheat if there is cookware or food inside; remove these items to reduce preheat time. The number of racks in the oven can also affect preheating time, so remove some racks if necessary. Different cooking modes use different preheat methods, with some taking longer than others, like convection bake.
What causes excessive smoking during the clean cycle of GE PSS93?
Excessive smoking during a GE Ranges clean cycle is often due to excessive soil or grease. Press the Cancel/Off pad, open windows to clear the smoke, wait for the LOCKED light to turn off, wipe up the excess soil, and then reset the clean cycle.
Why is my GE PSS93 Ranges oven door crooked?
If your GE Ranges oven door is crooked, it may be out of position due to being removed during installation. Re-install the door following the 'Lift-Off Oven Door' instructions in the 'Care and Cleaning' section.
Why does my GE Ranges surface unit stop glowing when turned to a lower setting?
It is normal for a GE Ranges surface unit to stop glowing when turned to a lower setting. The unit is still on and hot.
Why am I unable to set cook time or delay time on my GE PSS93 Ranges?
If you're unable to set cook time or delay time on your GE Ranges, it's likely because you forgot to enter a cooking mode first. Refer to the Cooking Options section for instructions.
What does it mean when “F— and a number or letter” flash in the display of GE Ranges?
When “F— and a number or letter” flash in the display of your GE Ranges, it indicates a function error code. Press the Cancel/Off pad and allow the oven to cool for one hour before putting it back into operation. If the error code repeats, disconnect power to the oven for at least 30 seconds, then reconnect it. If the error persists, call for service.
Why won't my GE PSS93 Ranges surface unit maintain a rolling boil?
Your GE Ranges surface unit might not maintain a rolling boil because of improper cookware. Use flat pans that match the diameter of the surface unit. Alternatively, low voltage in your area could be the cause. Try covering the pan with a lid to retain heat until the desired temperature is reached.
General| Type | Slide-In |
|---|---|
| Number of Burners | 5 |
| Self-Cleaning | Yes |
| WiFi Connect | Yes |
| Convection | Yes |
| Color | Stainless Steel |
| Width | 30 in. |
Instructions for securing the range to prevent tipping hazards and ensure safety.
Essential safety guidelines for operating the appliance safely and preventing common hazards.
Specific safety precautions for operating the cooktop to prevent burns and fires.
Key safety measures to follow when operating the oven to prevent hazards.
Information regarding FCC compliance and safety for the appliance's wireless communication equipment.
Guide to operating surface cooking elements, including warming zone and synchronized burners.
Recommendations for cookware selection and guidelines for achieving best results.
Explanation of oven controls, cooking modes, Sabbath mode, and probe usage.
Instructions for oven rack usage and adjusting appliance settings like clock and WiFi.
Instructions for cleaning the range's exterior, control panel, and stainless steel surfaces.
Methods for manually cleaning the oven interior and using the Steam Clean mode.
Detailed steps for cleaning the glass cooktop, including residue and spill removal.
Instructions for replacing the oven light bulb and caring for the oven door.
Solutions for problems related to surface units, cooktop performance, and appearance.
Troubleshooting oven temperature, operation, noise, and cleaning cycle issues.
Resolving function errors, display problems, and unusual odors or sounds.
Guidance for issues with cook time, racks, drawers, steam clean, and probe prompts.
Information on the one-year limited warranty coverage for GE electric ranges.
List of conditions not covered by the warranty and limitations on implied warranties.
List of optional accessories like broiler pans and essential replacement parts.
Recommended cleaning products for maintaining the appliance's surfaces and cooktop.
Accessing the GE Appliances website for support, registration, and product information.
Information on scheduling service, extended warranties, and contacting customer relations.
