GE PTW900BPTRS - Control Panel and Display Features

6 49-3000295 Rev. 0
Start/Pause
Press Start to begin the cycle. NOTE: Unless Bulky cycle is selected, the lid must be closed for the washer to start cycle. If the
lid is open, Lid will scroll across the display. During the load sensing portion of the cycle, the lid will lock and SEnSing will scroll
across the display. When load sensing is complete, the lid will unlock.
Pressing Pause will unlock the lid (if locked at that time), pause the cycle and the Start indicator light will blink.
To continue the cycle, press Start again. If water remains in the machine, select the Drain & Spin cycle to drain basket and
spin water out of the washer basket. NOTE: Machine will automatically cancel and drain when water is present and the lid is
left open for 15 minutes or the unit is left in a paused state for 24 hours with the lid closed. Select cycle and press Start to
begin new cycle.
B
Getting started
USING THE WASHER
A
Power
Press to wake up the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
DCA
B
E
F
F
F
F
D
A
B
F
E FG F
C
Features and appearance will vary.
D
A
B I
F
E FG
C
H
H