GE QDT125 Series User Manual (English)

Questions and Answers:

C
Christina SmithSep 15, 2025
What noises are normal for a GE QDT125?
- S
  Steven ColemanSep 15, 2025
  Normal operating sounds include beeping at the end of the cycle, the detergent cup opening, water entering the dishwasher, the motor stopping and starting at various times during the cycle, the spray arms starting and stopping at various times, drain pump sounds during pump out, and the drain pump starting and stopping several times during each drain. These are all normal. If you hear rattling dishes when the spray arm rotates, make sure dishes are properly loaded. If you hear rattling silverware against the door during the wash, tall utensils may be placed in the upper rack to avoid bumping against the inner door during the wash cycle.
S
Sharon GregoryAug 30, 2025
How to stop my GE Dishwasher from beeping at the end of the cycle?
- W
  Wendy ThomasAug 30, 2025
  The beeping at the end of the cycle is normal. The dishwasher will beep (unless interrupted) and the Clean light will display at the end of the wash cycle.
H
Holly RichardsonAug 25, 2025
What to do if my GE QDT125 Dishwasher won’t run?
- D
  Daniel MunozAug 26, 2025
  If your GE Dishwasher won’t run, start by checking the fuse or circuit breaker and replace or reset it, removing any other appliances from the circuit. Ensure the power is turned on, especially if it's controlled by a wall switch. Also, check if the control panel is locked and unlock it. As a final step, try rebooting the control by turning off power to the dishwasher (at the circuit breaker or wall switch) for 30 seconds, then turning it back on.
C
Cindy VaughnAug 26, 2025
Why won’t water pump out of my GE QDT125 Dishwasher?
- R
  rebeccamillerAug 26, 2025
  If water won’t pump out of your GE Dishwasher tub, the drain might be clogged. If you have an air gap, clean it. If the dishwasher drains into a disposer, run the disposer to clear it. Check to see if your kitchen sink is draining well; if not, you may need a plumber.
J
John MooreAug 26, 2025
Why is water standing in the bottom of my GE Dishwasher (Built-In Models Only)?
- J
  Joseph HernandezAug 27, 2025
  If water is standing in the bottom of the tub of your GE Dishwasher (Built-In Models Only), the air gap may be clogged, so clean the air gap. If a high drain loop or air gap is not installed, refer to the Installation Instructions for proper drain line installation.
J
jacksondavidAug 27, 2025
Why does my GE QDT125 Dishwasher beep once every minute?
- A
  Austin JamesAug 27, 2025
  If your GE Dishwasher BEEPS once every minute, this is a reminder that your dishwasher door has been left open during operation. Press Start and close the door.
A
Alfred GordonAug 27, 2025
What to do if the control panel responds but my GE QDT125 Dishwasher never fills with water?
- L
  lopezdonnaAug 27, 2025
  If the control panel of your GE Dishwasher responds to inputs but the dishwasher never fills with water, make sure the door is firmly closed. Also, make sure the water valve (usually located under the sink) is turned on.
L
laurendavisAug 27, 2025
Why is my GE QDT125 beeping at the end of the cycle?
- A
  Alexa RitterAug 27, 2025
  This is normal operation. Your GE Dishwasher is designed to beep at the end of the cycle. The dishwasher will beep (unless interrupted) and the Clean light will display at the end of the wash cycle.
A
Austin SandovalAug 28, 2025
How to fix GE QDT125 dishes that don’t dry?
- J
  Jeff CookAug 28, 2025
  If your dishes aren't drying, make sure the door is opened immediately after the Clean light comes on. Also, check that the inlet water temperature is at least 120°F, use Wash Temp Boost, and select a higher cycle like Heavy. Finally, ensure the rinse agent dispenser is filled as needed.
P
Peter WrightAug 28, 2025
What to do if my GE QDT125 Dishwasher control panel responded to inputs but dishwasher never filled with water?
- R
  Richard EllisAug 28, 2025
  If the control panel responds but the dishwasher doesn't fill with water, ensure the door is firmly closed and that the water valve (usually under the sink) is turned on.

GE QDT125 Series Specifications

General

Type	Built-In
Drying System	Heated Dry
Control Type	Electronic
Noise Level	64 dBA
Front Controls	Yes
Number of Options	4
Third Rack	No
Racking Material	Plastic
Water Filtration System	Yes
Place Settings	12