To Next PageTo Next Page
Need help?Do you have a question about the GE WX09X70910 and is the answer not in the manual?
General| Brand | GE |
|---|---|
| Model | WX09X70910 |
| Category | Dishwasher |
| Language | English |
Read all instructions and notes before beginning the dishwasher installation process.
Observe governing codes, ensure proper enclosure access, and follow essential installation requirements.
Follow all safety instructions, wear protective gear, and understand electrical shock and fire risks.
Identify the included parts: wood screws for countertop mounting and color-matched toekick screws.
List of materials needed, including plumbing fittings, seal tape, wire nuts, and drain/water line components.
List of necessary tools, such as screwdrivers, wrenches, level, measuring tape, safety glasses, and tubing cutter.
Details on enclosure dimensions, clearances, and ensuring the dishwasher is fully enclosed.
Follow local codes for drain lines, air gaps, high drain loops, and preventing backflow.
Drill a 1-1/2" diameter hole in the cabinet wall for drain hose and other connections.
Ensure power is off, use correct voltage, and follow grounding instructions for safe electrical wiring.
Route wiring through appropriate holes, ensuring sharp edges are covered and connections are secure.
Connect cable direct or install a power cord receptacle according to code and instructions.
Connect hot water supply with a shut-off valve, using 3/8" copper tubing, and flush the line.
Ensure the dishwasher door opens and closes smoothly by adjusting spring tension for balance.
Adjust the four leveling legs to ensure the dishwasher is level for optimal operation.
Remove the toekick by unscrewing the four retaining screws for access to leveling legs.
Connect incoming power cord wires (white, black, ground) using appropriate wire nuts.
Wrap the 90° elbow with thread seal tape and install onto the water valve, facing the rear.
Route water supply line and house wiring on the floor of the opening to avoid interference.
Insert the dishwasher drain hose into the cabinet wall hole, guiding it carefully.
Slide the dishwasher into the cabinet, ensuring front corners are flush and no components are pinched.
Use a level to check front-to-back and side-to-side balance, adjusting legs as needed.
Fasten the dishwasher to the underside of the countertop using the provided Phillips screws.
Connect the water supply line to the 90° elbow using compression nut and ferrule.
Connect the drain hose to the air gap, waste tee, or disposer following the determined method.
Use couplers to extend the drain hose if needed and secure all connections with hose clamps.
Connect dishwasher wires (white, black, green) to house wiring using wire nuts and a strain relief.
Review checklist items to ensure correct installation before operating the dishwasher.
Run a RINSE ONLY cycle to check water entry, leaks, draining, and door alignment.
Reinstall the two-piece toekick, aligning slots and securing with screws.
Ensure the complete literature package and installation instructions are left with the consumer.
Attach and connect the Unicouple to the faucet adapter for portable dishwasher operation.
Turn off water, release pressure, and disconnect the Unicouple from the faucet adapter.
