Programming With Code Search
If your TV, VCR, DBS Satellite System, Cable
Box or Audio System does not respond after
you have tried all the codes for your brand,
or if your brand is not listed, try searching
your code by following the steps below:
1. Manually turn on the device you wish to
program.
2. Press and hold the
CODE SEARCH until the
INDICATOR LIGHT
lights, then release CODE
SEARCH.
3. Press and release the
device button for the
device you are program-
ming. The INDICATOR
LIGHT will blink
once, then remain lit.
NOTE: For AUX program-
ming carry out program-
ming procedure on page
11 for the device you are
assigning to AUX prior to
starting a Code Search.
4. Press and release ON•OFF until your
device turns off.
5. When your device turns off, press
ENTER, the INDICATOR LIGHT will turn
off.
To Next Page
Loading...
Need help?
General
