GE SmartWater GXRM10 - Connecting to Icemaker (Model PNRV18)

CONNECTING TO THE ICEMAKER FOR MODEL PNRV18
I. Locate 3/8" robing I}lat suppfies file product water 1(7dm
RO fsuco. At a couveuieut point hel_veen lhe fhucet mid tile
electronics box, cut tile robing aud iustall the 3/8" tee fitting.
Conuect one end of tile 33 fi. leugth of 3/8" blue robing to tile
lee, as showu ill Fig. 13.
:2. Tom off the icemaker. Tum off current iceInaker water _mrce
(if applicable). Discolmect the present water _mrce tubing
froln tile refi_igeraUm
3, Connect lhe brass tubing adapter from tile parts bag to tile
free end of the 33 ft. length of 3/8" bhte tubing. Attach the
o/her end of the adapter to the icemaker water valve. Be sure
1(7 install the plastic wa_sher in|o file robing adapter as shown
in Fig. 14.
4. Turn on file water supply to tile Reverse Osmosis systeIll. Check
lhe shumffvalve on top of the extra storage tank m ensure it is
in tile open position. Smfifize the system (see next page).
5. Check the installation for leaks. Turn tile icelnaker back on.
Fig. 14
tubing
adapu r_ Plastic
., ,a_as lie F
Icemak_ r
Fig. 13
Fig. 12
This tubing adapter can Ix used
on m(_t icemak_ rs. ObU_in Iw_d¢_d
fitting for othei_.
RO _'at er
faucet
icemaker
II
II
II
II
lnser_
To drain
point
I/8" mbing
Tank s
Storage tank