GE VersaMax IC200BEM003 User Manual

VersaMax*
IC200BEM003
GFK-2739 PROFIBUS Master Module
April 2012
The VersaMax
*
IC200BEM003 PROFIBUS Master Module allows a VersaMax
CPU005, CPUE05 or PROFINET Scanner (PNS) to send and receive data on a
PROFIBUS-DP V1 network.
The PROFIBUS Master module provides the following PROFIBUS
communications features:
 Supports all standard data rates
 Supports a maximum of 3,584 bytes of input data and 3,584 bytes of output
data with a VersaMax CPU; a maximum of 1440 bytes of input data and 1440
bytes of output data with a PNS.
 Supports a maximum of 125 PROFIBUS-DP slaves, with a maximum of 244
bytes of input data and 244 bytes of output data for each slave
 Supports Sync and Freeze modes
 Supports DP-V1 Read, Write and Alarm messages
 Has PROFIBUS-compliant module and network status LEDs
This module must be located in a VersaMax Communications Carrier.
The PROFIBUS module receives its firmware upgrades indirectly from the
head end CPU or PNS using the WinLoader software utility. WinLoader is
supplied with any updates to the PROFIBUS module software.
Ordering Information
IC200BEM003
VersaMax PROFIBUS Master Module
IC200CHS006
VersaMax Communications Carrier
Specifications
PROFIBUS support
PROFIBUS-DP V1
Power Consumption
450mA at +5V
I/O Data
With a CPU
A maximum of 3584 bytes of input data and 3584 bytes of output data
With a PNS
A maximum of 1440 bytes of input data and 1440 bytes of output data
With either CPU or PNS head end, a maximum of 244 bytes of input data and 244
bytes of output data for each slave.
PROFIBUS network addresses
0 to 125, software-configurable
Maximum no. of slave devices
125
Network data rate
9.6K up to 12 Mbaud (bit/sec)
Status information
Slave Status Bit Array Table
Firmware Module Revision
Slave Diagnostic Address
Module isolation
Network to Frame ground: 250VAC continuous, 1500VAC for 1 min
Profibus network to backplane: 1500VAC minimum
For product standards, general operating specifications, and installation requirements, refer to the VersaMax I/O Modules
Manual, GFK-1504.
*
indicates a trademark of GE Intelligent Platforms, Inc. and/or its affiliates. All other trademarks are the property
of their respective owners.

GE VersaMax IC200BEM003 Specifications

General

Model Number	IC200BEM003
Series	VersaMax
Product Type	Control Unit
Manufacturer	GE
Input Voltage	24 VDC
Humidity	5 to 95% non-condensing
Communication Protocol	Modbus
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 85°C
Communication Ports	RS-485

Summary

PROFIBUS Master Module Overview

PROFIBUS Communications Features

Key features of the PROFIBUS Master Module, including data rates and slave support.

Ordering Information

Details for ordering the PROFIBUS Master Module and related components.

Specifications

Key technical specifications of the PROFIBUS Master Module.

Installation and Diagnostics

Installation in Hazardous Areas

Guidelines and warnings for installing the module in hazardous locations.

ATEX Marking

Details on ATEX certification and suitability for hazardous environments.

Diagnostic Status Arrays

Explanation of various diagnostic arrays used by the module.

PROFIBUS Master Module LEDs

Information on the status LEDs of the PROFIBUS Master Module.

Quick Start Guide and Network Setup

Quick Start Guide

Steps for installing the module and carrier, and connecting the PROFIBUS bus.

PROFIBUS Connector Pin Assignments

Details of the pinout for the PROFIBUS connector.

Module LED Status

Interpreting the LED indicators for module status.

PROFIBUS Network Termination

Requirements for active bus termination in a PROFIBUS network.

Product Information and Compatibility

Important Product Information for this Release

Details on the release history and version information.

Compatibility

Required programming software and CPU versions for the module.

Restrictions and Open Issues

Known issues and limitations with the PROFIBUS Master Module.

Operational Notes and References

Operational Notes

Important notes on module operation and potential error conditions.

References

List of related manuals and documentation for further information.