GE HEALTHCARE - KRETZTECHNIK VOLUSON® 730EXPERT (BT03)
D
IRECTION 105899, REVISION 3 DRAFT (APRIL 29, 2008) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-37
3-7-4-1 HP 990cxi / HP 995c - Printer Settings
1.) Call up the ‘Printer Properties’; operation see: Section 3-7-4 "Adjustment of Printer Settings" .
2.) Select the
GENERAL page and click the PRINTING PREFERENCES... button.
3.) Select the
SETUP page for adjusting print quality and paper size.
“Paper type” should be set to ‘Automatic’. See left Figure 3-43.
4.) Select the
FEATURES page for adjusting ‘Two-Side Printing’ if desired.
“Orientation” must
be set to ‘Portrait’. See right Figure 3-43.
5.) For saving the adjusted printer settings click APPLY
and then OK.
6.) Select the
PORTS page and select/verify the correct USB printer port.
7.) For saving the adjusted printer settings click APPLY
and then OK.
Finally close the ‘Printers’ -window with the close button and exit System Setup with SAVE&EXIT
.
8.) Assign the HP 990cxi / HP 995c printer as Report Printer;
see: Section 3-7-5 "Remote Control Selection" on page 3-40.
9.) Print report page(s) containing measurements.
For operation see Basic User Manual of Voluson® 730Expert.
10.)Turn off the system!
Figure 3-43 HP Printer - Settings
To Next Page
Loading...
