– 45 –
Note: When reinstalling the nozzle to the gasket, it
may be helpful to remove the nozzle from the hose.
Ensure that the washer is placed on the outside
and that the nozzle is aligned with the indent on the
inside of the gasket.
Gasket Outside Gasket Inside
Washer
Indent
Nozzle
Disengage the gasket from the water inlet pipe.3.
Loosen the 7-mm bolt that holds the wire and
bolt assembly to the outer tub lip. Remove the
wire and bolt assembly from the tub gasket.
Note: When reinstalling the wire and bolt, tighten
to a gap of approximately 1
1
/
4
inches (as shown). Do
not overtighten.
4.
Gasket
Water Inlet Pipe
Wire and Bolt Retainer
1
1
/
4
-in. Gap
Pull the tub gasket off the outer tub lip.5.
Outer
Tub
Lip
Note: When reinstalling the tub gasket on the
outer tub, align the notch in the gasket with the
arrow located on the top of the outer tub lip before
tightening the wire and bolt assembly.
Arrow
Notch
To Next Page
Loading...
