GE WSLP1500H0WW - Troubleshooting Fault Codes; Fault Code Reference

– 20 –
Fault Codes
Fault
Code
Name Description Repair Action
Water level does
not rise to the
set level in 60
minutes
For “H1~H2”
models Set time
is 12 minutes.
• House water supply
closed
• Clogged valve and/or
hose screens
• Clogged, kinked or
pierced pressure hose or
chamber hose connect
• Open house water supply
• Clean valve and/or hose screens
• Clean or replace hose, clean chamber
where hose connects
Water does
not drain out of
tub within 60
minutes
• Drain pump clogged
• Drain pump inoperative
• Pinched internal/
external drain hose
• Clogged in tub
• Pressure sensor
defective
• Clear clog from pump
• Replace drain pump
• Repair/replace hoses
• Clear clog from tub
• Replace pressure sensor
Unbalanced load • Washer not level
• Uneven clothes
distribution
• Balance ring empty or
basket out of round
• Pressure sensor bad
• Level washer per installation instructions
• &XVWRPHU(GXFDWLRQ6HSDUDWHGLȺHUHQW
materials
• Manually redistribute materials
• &KHFNEDODQFHULQJIRUÀXLGLIQRQH
replace
• Replace pressure sensor
Water level too
high
• Leaking water valve
• Pressure sensor
frequency out of range
• Hole in pressure sensor
hose or disconnected
• Harness connecter not
connected or damaged
• Replace water valve
• Replace pressure sensor
• Replace pressure hose
• Reconnect connecter or replace harness
Lid shows Open
when closed,
intermittent
during spin
• Lid warped or damaged
• No lid magnet
• Lid switch defective
• Replace damaged part
• Replace/reinstall missing magnet
• Replace Machine Control
Pressure sensor • Not connected
• Out of range/ Damaged
• Reconnect harness connecter
• Replace sensor
Load size sensor • Will not sense load size • Check motor and clutch operation
• Check belt tension, tighten if necessary
• Check harness and connecters from
control to the motor
• If above is good, replace control