– 22 –
UI and Machine Control Removal
1. Close the lid and lay a towel over the washer
to protect the product. Disconnect all harness
connecters from the machine control (MC).
2. Remove the four Phillips head screws that
attach the boards to the control panel.
3. Lift the control board assembly up from the
screw locations to disengage it from the three
rear mounting tabs.
4. Place the control panel and towel aside.
Rear Component Cover Removal
Removal of the rear component cover provides
access to the power cord connections, water valve,
pressure sensor, dispenser box and lid springs.
The rear component cover is held to the rear of the
top cover with two Phillips head screws on the rear
of the washer and seven snap tabs located inside
the back cover. After removal of the screws, the
cover can be lifted straight up. The tabs will release
when lifted.
To Next Page
Loading...
