EasyManua.ls Logo

GE XL44 JGBP24 - Page 25

GE XL44 JGBP24
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
How to Set the Oven for Cleaning
Quick Reminder:
1. Latch the door.
2. Turn the OVEN SET knob to CLEAN.
If the oven is too hot and you start to set a clean cycle,
you will not be able to slide the latch.
Allow additional time for cooling before you try to set
the cycle.
1. Follow directions to prepare the oven for cleaning.
2. Slide the latch handle to the
right as t:ar as it will go.
Never force the latch
handle. Forcing the handle
will damage the door lock Illl_
mechanism.
3. Turn the OVEN SET knob to CLEAN. The SELF
CLEAN DOOR LATCH, AUTOMATIC OVEN,
OVEN ON and COOK TIME ON/OFF lights
will glow.
NOTE: If you turn the OVEN SET knob betbre
you slide the latch, the SELF CLEAN DOOR
LATCH light will flash. Slide the latch to the right.
Clean cycle time is normally 4 hours and
20 minutes. On some models, you can change the
Clean Time to anywhere between 3 hours and 5 hours
and 59 minutes, depending on how dirty your oven is.
You have one minute to change your Clean Time.
Use the HOUR and MIN. pads to change the total
Clean Time.
Both the OVEN ON light and the SELF CLEAN
DOOR LATCH light will flash when the Clean Time
is finished.
After using the clean cycle, the door latch and the
OVEN SET knob must be returned to their original
positions before you can use the oven.
When the SELF CLEAN DOOR LATCH light
flashes, slide the latch handle to the left as far as it
will go, turn the OVEN SET knob to OFF and open
the door.
Never force the latch handle. Wait until the SELF
CLEAN DOOR LATCH light flashes and the latch
slides easily. Forcing the latch handle may damage the
door lock.
To Stop A Clean Cycle
1. Turn the OVEN SET knob to OFF.
2. Wait until the oven has cooled below the locking temperature to unlatch
the door. You will not be able to open the door right away unless the oven
has cooled below the locking temperature.
After a Clean Cycle
You may notice some white ash in the oven.
Just wipe it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad. Be sure to rinse thoroughly
with a vinegar and water mixture. These deposits
are usually a salt residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
NOTE:
You cannot set the oven for cooking until the oven is
cool enough for the door to be unlatched.
While the oven is self-cleaning, you can press the
CLOCK pad to display the time of day. To return
to the clean countdown, press the COOK TIME
ON/OFF pad.
(c'o_ti_:ed tTe.vtpage)
25

Related product manuals