Careand cleaning of the range.
Sealed Burner Assemblies (onsomemodels)
Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and
drip pans (if' so equipped) can be lifted ofl_
making them easv to clean.
Drippan onsomemodels
CAUTION:Do not operate the
burner without all burner parts and
drip pans (if so equipped) in place.
Electrode__
.......................................
The electrode of the spark igniter is
exposed when tile bm'ner head is
removed. _._l/en one bm'ner is turned
to LITE, all tile burnei_ spark. Do not
attempt to disassemble or clean
around any burner while another
bm'ner is on. An electric shock may
result, which could cause w>u to
knock over hot cookware.
Use a sewing needle or twist-tie
to unclog the small hole in the
burner head.
After cleaning, make sure rite slot
in the burner head is positioned
over flTeelectrode.
Burner Heads (onsealedburners only)
NOTE."Beforeremoving theburner heaflsand
caps, rememberthek size and location. Replace
them in the same location after c/eanlbg.
For proper ignition, make sm'e tile
small hole in the section that fits over the
electrode is kept open. A sewing needle or
wi_e twist-tie works well to tmclog it.
Theslits in theburner headsof yourrange
must be kept dean at a// times for an even,
unhamperedflame.
You should clean tile sm'fi_ce bm'ne_s
routinely, especiall) after bad spilloxe_,
which could clog these oi)enings, .
To relnove bm'ne&on food, soak tile
burner heads in a solution of mild liquid
detergent and hot water fi_r 2%30 minutes.
FoI" iiloi'e stubborn stains, rise _1 toothbrush,
Before putting tile bm'ner head back, shake
out excess water and then (hT it thoroughly
by setting it in a wam_ oven for 30 minutes.
Replace tile bm'ner heads and caps. Make
stlre that the heads and caps are replaced
in the correct location. There is one small,
2 medium and one large head and cap.
NOTE: Onsome models there,are 2 large,,
one medium and onesmall headand cap.
Mediun!
Large
Burner Caps (onsealed burners only)
i,ifl off when cool. _._hsh burner caps in hot,
soapy water and rinse with clean water
You may scorn" with a plastic scorning pad
to remove bm'ned-on food particles.
D_T them in a wam_ oven or with a cloth--
don't reassemble them wet. Replace the
burner caps.
Make sm'e that caps are replaced on tile
correct size bm'ne_: There is one small,
2 medium and one large cap.
NOTE: Onsome models thereare 2 large,one
medium and onesmafl headand cap.
28
To Next Page
Loading...
