GE ZGP366N - Page 11

Installation
STEP 2 MOVE THE RANGE INDOORS
1 Tilt the range forward on the skid.
__Toekick
2 Lift the toekick out of the foam base.
4 Attach the hand-truck straps around the unit.
IMPORTANT: Place the hand-truck straps below
the oven door handles. To avoid damaging the
side panels, place a pad between the hand-truck
and the range.
5 Tilt the range to lower the hand-truck wheels
off the skid.
Hand-Truck
Strops Below
Oven Door
Handles
/ _i_iii¢_i¢,_i_
3 Drive the blade of the hand-truck beneath
the foam block.
6 Place the appliance runners on the floor
at the left and right sides in front of the opening.
IMPORTANT: The runners provide a surface for
rolling the range into the final oosition and will
protect the floor finish. The runners must be
removed before leveling the range.
7 IVlove the range indoors. Position the range
in front of the installation location, onto
the runners.
Insert Blade Under
the Foam Block
You may need to remove the
front of the foam block to fit
through the doorway.
IMPORTANT: Do not remove the base foam
block while the hand-truck is in use. Place
the hand-truck blade underneath the base
foam block and transport the range to the final
location.
11