EasyManuals Logo

GEA Bock HGX44e/475-4 User Manual

GEA Bock HGX44e/475-4
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28
D
GB
F
E
96416-08.2020-DGbFEIRu
8 | Commissioning
8.1 Preparations for start-up
8.4 Evacuation
Firstevacuatethesystemandthenincludethecompressorintheevacuationprocess.
Relievethecompressorpressure.
Openthesuctionandpressurelineshut-offvalves.
Evacuatethesuctionanddischargepressuresidesusingthevacuumpump.
Attheendoftheevacuationprocess,thevacuumshouldbe<1.5mbarwhenthepumpisswitchedoff.
Repeatthisprocessasoftenasisrequired.
ForHCandLGcompressorssuitableequipmentapprovedforammablerefrigerants
mustbeused.
Thecompressorhasundergonetrialsinthefactoryandallfunctionshavebeentested.Thereare
thereforenospecialrunning-ininstructions.
Checkthecompressorfortransportdamage!
8.3 Leaktest
CarryouttheleaktestontherefrigeratingplantinaccordancewithEN378-2oracorresponding
safetystandard,whilealwaysobservingthemaximumpermissibleoverpressureforthecompressor.
INFO
Toprotectthecompressoragainstinadmissibleoperatingconditions,
highpressureandlowpressurepressostatsaremandatoryonthe
installationside.
DANGER Riskofbursting!
The compressor must only be pressurised using nitrogen (N
2
).
Never pressurisewithoxygenorothergases!
Themaximum permissibleoverpressure of thecompressor must
notbeexceededatanytimeduringthetestingprocess(seename
platedata)! Do not mix anyrefrigerant with thenitrogen asthis
couldcausetheignitionlimittoshiftintothecriticalrange.
ATTENTION Donotstartthecompressorifitisundervacuum.Donotapply
anyvoltage-evenfortestpurposes(mustonlybeoperatedwith
refrigerant).
Undervacuum,thespark-overandcreepagecurrentdistancesofthe
terminalboardconnectionboltsshorten;thiscanresultinwindingand
terminalboarddamage.
8.2 Pressureintegritytest
Thecompressorhasbeentestedinthefactoryforpressureintegrity.Ifhowevertheentiresystemis
tobesubjectedtoapressureintegritytest,thisshouldbecarriedoutinaccordancewithEN378-2
oracorrespondingsafetystandardwithouttheinclusionofthecompressor.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GEA Bock HGX44e/475-4 and is the answer not in the manual?

GEA Bock HGX44e/475-4 Specifications

General IconGeneral
BrandGEA
ModelBock HGX44e/475-4
CategoryAir Compressor
LanguageEnglish

Related product manuals