7 / 13
■Press[◀/▶]to move cursor to select frequency, the signal strength
of the selected frequency will be displayed on the right-top corner.
Press "OK" to scan the current frequency point blindly
3.2.3 Angle Calculation.
Move cursor to“Angle Calculation ’’and press“OK’’ , then you can
enter the“Angle Calculation’’ interface.
■Press [▲/▼] on the "Satellite" option to select an existing satellite,
The longitude of the satellite will change accordingly.
■Press [▲/▼] on the satellite longitude option, and then enter the
Satellite longitude.
■If you select "Manual", you can move the cursor to "Local Longitude"
And local latitude, enter the parameters you want to enter
(Press [◀/▶] to select east or west local longitude, south or north
hemisphere).
■After changing the parameters, the system will calculate the result and
The picture will be automatically displayed on the screen.
3.2.4 Constellation
Move cursor to“Constellation ’’ and press“OK’’ , then you can enter the
“Constellation ’’ interface.
To Next Page
Loading...
Need help?
General