Gecko in.k1000 Quick Reference Card

1
wifi
(This function is available only if an in.touch module is connected to your system.)
wifi settings
To modify wifi network settings, slide the right
wheel until the wifi icon is highlighted in the
middle.
in.touch module not connected
If the in.touch module of your spa system is not
connected, this message will be displayed.
wifi networks
After a few seconds the available networks will
appear on the screen, as well as their signal
strength.
Selected network will be identified by a green
check mark.
Swipe Up or Down the list to select your network.
wifi network password
If the wifi network is password protected, enter
it when keyboard prompts. Use Enter key to
validate the password.
If no password is required the in.touch will
connect automatically.
about your spa system
electrical configuration
about
To get info about your spa system, slide the right
wheel until the about icon is highlighted in the
middle.
Information about the in.k1000 software number
and the revision numbers of the different
components of your system will be displayed.
Please do not make changes in this section
unless you are a qualified electrician.
To change the low-level configuration, the number
of phases and the input current of your spa
system, slide the right wheel until the electrical
configuration icon is highlighted in the middle.

Gecko in.k1000 Specifications

General

Brand	Gecko
Model	in.k1000
Category	Keypad
Language	English