10
Program menu
Instructions listed in this section assume the Program key is
used, but if there is no Program key on the keypad, use the
Light key instead.
The program menu is accessible by holding down the
Program key for 5 seconds� In the program menu the
following parameters can be set: clock, filter or purge cycles,
economy mode, heat pump mode and temperature units�
While in the program menu, use the Up or Down key to
adjust the parameters and use the Program key to jump
to the next parameter� The changes will be saved after the
confirmation of the last parameter only�
If there is no action taken for 15 seconds, the system will exit
the program menu and all changes will be saved�
Setting the clock
Enter the program menu by holding down the Program key
for 5 seconds� The display will show the current clock setting
with the hour flashing�
Depending on factory settings, your system may be set
to 24-hour time or 12-hour time� An additional dot can be lit
under the “:” separating hours and minutes to serve as an
AM icon�
Setting the hour: Use the arrow keys to adjust the hour� Press
the Program key to jump to the next parameter, the minutes�
Setting the minutes: Use the arrow keys to adjust the
minutes� Press the Program key to jump to the next
parameter, the filter or purge start time (FS)�
Programming the filter/ purge cycles
Depending on system configuration, your spa will
perform either a filter or a purge cycle� The filter cycle
menu consists of the following parameters: the start time
(FS), the duration (Fd) and the frequency (FF)� The purge
cycle menu consists of the following parameters: the start
time (FS) and the frequency (FF)�
A filter cycle consists of starting all the pumps and blower
in high speed for 1 minute (purge step) then, the pump
associated with the filter will run in low speed for the
remaining duration of the filter cycle (clean step)�
A purge cycle is used when the spa is equipped with a
24 hour circulation pump which provides a continuous
clean step� It consists of starting all the pumps and blower
in high speed for 1 minute�
Programming steps
To Next Page
Loading...
Need help?
General
