Gecko in.xm2 - User Manual

To Next Page

2- Connect the main power

1- Connect all outputs & keypads

Fuses

Power box display and buttons

Main power entry connection

Main power cable input entry

Mounting feet

Installation brackets

OUT1

L1 - Light connector General I/O connector

(IR receiver)

C - Main and aux. keypad connectors

CO - Communication link

OUT8 - Connector for direct 120/240 vac

5 Amp output

OUT7

OUT5

OUT6

OUT2 OUT3 OUT4

Don't forget that the voltage is determined by the cable used (120 or 240V cable)!

For 240 VAC (*3 wires)

* If connected to a 3 wire system (without neutral),

all 120 VAC components will not work.

For 240 VAC (4 wires)

Correct wiring of the electrical service box, GFCI,

and pack terminal block is essential.

Call an electrician if necessary.

RH - Output connectors for in.therm™

remote heating system (240 vac)

4- Select breaker current

Make sure all accessories are linked to the bonding connector and connected to

pack. Make sure the spa pack door is closed. Turn on the breaker.

Bonding lug

3- Select spa configuration (see chart next page)

First, the led display will show "LL" and "01" continuously.

Press Change button to choose the appropriate

configuration for your spa.

Press Select button to confirm.

(The pack will now reset and reboot)

Note: To re-enter the configuration selection menu the press Select

button and hold for 5 seconds.

Press Change button to choose the breaker current value.

Press Select button to confirm.

(The pack will now reset and reboot)

Note: Br values display by the pack correspond

to 80% of the maximum amperage

capacity of the GFCI.

GFCI Br

60 Amp 48 Amp

50 Amp 40 Amp

40 Amp 32 Amp

25 Amp 20 Amp

20 Amp 16 Amp

Selecting breaker current (Br)

For more information, see our website: www.geckoalliance.com

Quick Start Card

in.xm2

™

North American version

Need help?

Do you have a question about the Gecko in.xm2 and is the answer not in the manual?

Summary

Connect Outputs and Keypads

Power and Communication Connections

Details main power entry, keypad, and communication link connectors.

Output Connectors

Lists output connectors for pumps, heating systems, and other accessories.

Connect Main Power

240 VAC Power Wiring

Instructions for 240 VAC 4-wire and 3-wire connections, emphasizing electrical safety.

Select Spa Configuration

Configuration Selection Process

Steps to choose spa configuration via keypad, including initial display and confirmation.

Re-enter Configuration Menu

Method to access the configuration menu again by holding the Select button.

Select Breaker Current

Breaker Current Selection

Procedure for selecting the appropriate breaker current value for the spa pack.

Breaker Current Table

Reference table correlating GFCI amperage with recommended breaker (Br) values.