Need help?Do you have a question about the Gecko Aeware Swim spa solution and is the answer not in the manual?
General| Brand | Gecko |
|---|---|
| Model | Aeware Swim spa solution |
| Category | Control Systems |
| Language | English |
Details for installing the in.k600™ keypad, including cut-out dimensions and cleaning.
Details for installing the in.k100™ keypad, including cut-out dimensions and cleaning.
Overview of electrical wiring for the North American in.xe™ spa control system.
Wiring diagram for North American in.xe™ with a single breaker.
Wiring diagram for North American in.xe™ with two breakers.
Wiring diagram for European in.xe.ce™ single phase installation.
Wiring diagram for European in.xe.ce™ dual phase installation.
Wiring diagram for European in.xe.ce™ three phase installation.
Instructions for programming the in.xe™ system using the in.stik™ device.
Instructions for programming the in.xe™ system using the keypad interface.
Chart listing low-level configurations, pump setups, and diagram page references.
Indicates an internal hardware error detected in the MASTER or SLAVE pack.
Indicates system shutdown due to high heater temperature (119°F / 48°C).
Indicates no water flow detected while the primary pump was running.
Indicates high water temperature in the spa (108°F / 42°C).
Indicates a problem with the regulation probe, verifying temperature probe readings.
Indicates high internal temperature in the spa equipment compartment.
No low-level configuration software has been downloaded into the system.
Communication failure between the MASTER and SLAVE packs.
Indicates the main keypad is connected to a SLAVE pack.
Unable to select the desired low level configuration.
Selected configuration is not a swim spa configuration with a SLAVE pack.
Troubleshooting steps for Hr or Hr2 internal hardware error.
Troubleshooting steps for HL or HL2 high heater temperature error.
Troubleshooting steps for FLO or FL2 no water flow error.
Troubleshooting steps for OH or OH2 high water temperature error.
Troubleshooting steps for Prr or Pr2 regulation probe issue.
Troubleshooting steps for AOH or AO2 high equipment compartment temperature.
Explanation of UPL error: missing low-level configuration software.
Troubleshooting steps for Erl communication error between packs.
Troubleshooting steps for SLA: main keypad connected to SLAVE pack.
Troubleshooting steps for LLXX: unable to select low level configuration.
Troubleshooting steps for LLEr: incorrect configuration or SLAVE pack detected.
Details electrical input and output specifications for UL/CSA standards.
Specifications for heat.wav ratings including voltage, current, and flow rate.
List of applicable European and Australian standards.
Details electrical input and output specifications for TUV standards.
Details operating/storage temperatures, humidity, water ingress, weight, and dimensions.
To Next Page
