Gecko Aeware Swim spa solution - Programming with Keypad

17
Swim Spa Solution™
Programming the in.xe™
using the keypad
Although every in.xe™ spa is
factory set, in certain cases
when servicing or replacing
a unit in the fi eld, it may be
necessary to set a new pre
determined low level program
confi guration into the spa pack.
Follow these simple steps
to re-enter the low level
programming menu using the
keypad:
3. Press the Prog. key to confi rm
the selected confi guration
(consult the low level
confi guration selection chart
section of this manual).
NOTE: If the Prog. key is not
pressed within 25 seconds, the
unit will exit this menu without
changing any settings
1. Press and hold the Pump 1
key for 30 seconds.
2. Use the Up/Down key to
choose the new desired low
level confi guration number.
programming the in.xe™
See low level confi guration chart page 18.