9
Swim Spa Solution™
To install the wiring for the
in.xe™ spa control, you'll need
a Phillips screwdriver and a fl at
screwdriver.
Loosen the 2 screws of the Spa
Pack door and open it.
Remove 5 1/2" of cable
insulation. Strip away 1" of each
wire insulation.
Pull the cable through the cut-
out of the box and secure it
bonding lug
with a strain relief (1" NPT strain
relief; hole diameter: 1.335").
Make sure that only the uncut
sheathing is clamped at this
opening.
Push the color-coded wires
into the terminals as indicated
on the sticker and use the fl at
screwdriver to tighten the
screws on the terminals.
After making sure wire connec-
tions are secure, push them
back into the box and close the
door. Tighten the 2 screws of
the Spa Pack door.
Connect the bonding conduc-
tor to the bonding lug on the
front of the in.xe™ Spa Pack
(a grounded electrode conduc-
tor shall be used to connect
the equipment grounding con-
ductors).
North American model in.xe
TM
electrical wiring
For 240 VAC (4 wires)
Correct wiring of the electrical
service box, GFCI, and pack
terminal block is essential.
Call an electrician if necessary.
To Next Page
Loading...
Need help?
General
