USER INSTRUCTIONS GH11RA STRONA 17
Wydanie I STYCZEŃ 2010
CAPILLARY TUBE PUNCTURE OR BREAKAGE INDICATES THAT
TEMPERATURE LIMITER FILLED WITH LIQUID LEAKS, WHICH RESULTS IN
ABNORMAL OPERATION OF THE GH13RA CONTROLLER.
IN CASE IF THE ABOVE-MENTIONED DEFECT IS FOUND, IT WILL BE
NECESSARY TO DISCONNECT TEMPERATURE LIMITER FROM THE
GH13RA CONTROLLER, REMOVE IT AND REPLACE WITH A NEW DEVICE.
10. PROCEDURE IN THE CASE OF CONTROLLER DAMAGE
In a case if have been noticed any irregularities in functioning of controller, user should contact with the
supplier / producer or GECO company. Professional technical assistance will be given to him. If service
assistance is indispensable (repair of the controller), damaged controller should be dismounted from the
boiler and sent as a set (together with casing) on indicated address.
SENDING A NOT COMPLETE CONTROLLER TO THE SERVICE CAUSES AN
AUTOMATIC LOSS OF THE GUARANTEE
PREPARING THE CONTROLLER TO DELIVERY TO THE SERVICE
STEP 1
Disconnect a controller
from power supply
(remove plug from power point)
STEP 2
Remove a front panel
by using of flat screwdriver
To Next Page
Loading...
Need help?
General
