1
45
Problems, possible causes and solutions
Question
Possible cause Solution
The power does not
open.
Fuse blown.
Replace the fuse with a suitable one.
If the fuse blows again, you should
contact Geely service station.
Improper device
connection.
Verify that the device is properly
connected.
System fault Low battery Charging the battery.
Poor picture color/
tone quality.
The brightness,
saturation and contrast
settings are not
reasonable.
Set the brightness reasonably in the
display settings.
If the problem still exists, please
contact Geely service station.
There is no sound.
Set the volume low or
mute state.
Set the volume or unmute reasonably
in the sound settings.
Poor connection.
Check to see if the device is
connected.
No sound is made
when the device is fast
forwarding, fast
rewinding, scanning, or
playing at low speed.
Cancel fast forward, fast rewind, scan
or low speed playback.
Poor sound or image
quality.
Vibration occurs at the
changeover switch.
Because of the vibration, the sound
may be short-circuited and the image
distorted, and the device will return to
normal once the vibration stops.
Poor image color/tone
quality.
Use images with high color/tone
quality.
USB does not work.
The USB disk is
damaged.
Format the USB drive to FAT16/32,
exFAT, NTFS and then use it.
The USB drive is
contaminated.
Remove impurities between the
contact surface of the USB disk and
the multimedia terminal.
The USB hub used
was purchased
separately.
Plug the USB drive directly into the
car's multimedia terminal.
Multimedia system
To Next Page
Loading...
Need help?
General
