Geemarc AMPLICALL10 User Manual

5
Trouble shooting
Symptom Solution
No incoming call yet the
Amplicall10 rings
automatically or rings
continuously; the
shaker vibrates
automatically or
continuously; the strobe
LED flashes
automatically.
1) Check the batteries are
inserted correctly.
2) Check the power
adaptor is connected
correctly.
3) Turn off the power
switch for 10 minutes
and then turn it on.
The red low battery
LED flashes
automatically.
1) Replace the batteries.
2) Turn off the power
switch for 10 minutes
and then turn it on.
When there is an
incoming call but no
ringing can be heard.
1) Check it is connected to
the power adaptor
correctly.
2) Check the batteries are
installed correctly.
3) Check if the volume
switch is switched on.
4) Check it is connected to
the line cord correctly.
INSTALLATION

Geemarc AMPLICALL10 Specifications

General

Brand	Geemarc
Model	AMPLICALL10
Category	Amplifier
Language	English