41
RS-232 SERIAL COMMANDS
CONTRST Command
The CONTRST sets the contrast level on the output signal.
Syntax:
CONTRST param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the contrast value by intervals of 1.
Use ? for param1 to retrieve the current value.
GREEN Command
The GREEN command sets the green color component value.
Syntax:
GREEN param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the color component value by intervals of 1.
Use ? for param1 to retrieve the current value.
To Next Page
Loading...