42
RS-232 SERIAL COMMANDS
HUE Command
The HUE sets the color hue level.
Syntax:
HUE param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the color hue by intervals of 1.
Use ? for param1 to retrieve the current value.
NR Command
The NR command sets the noise reduction value.
Syntax:
NR param1
Parameters:
param1 Mode
Mode Meaning
off Noise reduction Off
low Low noise reduction
mid Medium noise reduction
high High noise reduction
Notes:
Use ? for param1 to retrieve the current value.
To Next Page
Loading...