7
RECEIVER PANEL DESCRIPTIONS
1 Brightness Trim Pot
Use this adjustment Trim Pot to brighten/darken the output video signal. See
page 9.
2 Focus Trim Pot
Use this adjustment Trim Pot to focus/blur the output video signal. See page 9.
3 Power LED Indicator
This LED will become active once the included 5V DC power supply is properly
connected.
4 5V DC Power Input
Connect the included 5V DC power supply input this port. Once this has been
properly connected the power LED will become active.
5 3 RCA Component Output 1
Connect one component display device to this output.
6 3 RCA Component Output 2
Connect one component display device to this output.
7 2 RCA Analog Stereo Output 1
Connect this output to either the display or audio receiver.
8 2 RCA Analog Stereo Output 2
Connect this output to either the display or audio receiver.
9 SPDIF Digital Audio Output 1
Connect this output to either the display or audio receiver.
10 SPDIF Digital Audio Output 2
Connect this output to either the display or audio receiver.
11 Optical Digital Audio Output 1
Connect this output to either the display or audio receiver.
12 Optical Digital Audio Output 2
Connect this output to either the display or audio receiver.
13 RJ-45 Jack
Connect the sending and receiving units together using a TIA/EIA-568-B
terminated CAT-5, CAT-5e or CAT-6 cable. See page 10.
To Next Page
Loading...
