gefran 1600P User Manual

INP.2
AL.XB
0Vt.P
5 • PROGRAMMING and CONFIGURATION
F
If Inc, Dec, F keys are not pressed within 30 sec, display returns automatically to PV/SV value.
All INFO and dAtA data on config menu remain displayed and are not timed.
INFO
P.V. / S.V.
Process variable (PV display)
Current setpoint (SV display) or
manual control output
Value of ammeter input
or remote setpoint
(with auxiliary input enabled)
Alarm point 1 (scale points)
Alarm point 2 (scale points)
Alarm point 3 (scale points)
Heater break alarm point
(scale points of ammeter input)
Control output value
(+Heat / -Cool)
Press for
approx.
2 sec
Program settings
dAtA
ProG
StEP
InP
Out
PASS = 99
Prot
Lin
CuSt
Program step settings
Input settings
Output settings
Hardware configuration
Input linearization
“dAtA” menu setting
_CAL
Select calibration menu [ 0...12 ]
SI
NO
Keep the F key
pressed to scroll
the menus
Release the F
key to select the
displayed menu
Press the F key
to access the
parameters
Keep the F key
pressed to exit any
menu
Keep F + Auto/Man
keys pressed for 2
sec. on any menu
to go immediately
to level 1 display
(*)
(*)
S3 = ON
Current setpoint
(display only)
LEVEL 1 MENU
PASS
NO
SI
Hrd
U.CAL
S4 = ON
YES
NO
Custom menu
Password
User calibration
Protection code
(*) The automatic return PV/SV display is disabled for these displays
(**) Data can only be modified when the programmer state
is STOP (see “Programmer state”)
1
2
3
4
5
6
7
Information display
N.B.: Once a particular configuration is entered, all unnecessary parameters are no longer displayed
CFG
SEr
Control parameters
Serial communications
Program number, step, segment,
running time
Stato
Programmatore
(*)
(**)
Unit layout
CGrP
Setting of control parameter groups
SP
-
-
AL.1
-
AL.2
-
AL.3
-
DISPLAY BOARD
POWER
BOARD
CPU BOARD
SERIAL / W BOARD
DISPLAY
BOARD
POWER
BOARD
CPU
BOARD
SERIAL / W BOARD
380090G_MHW_1600-1800P_04-2013_ENG

gefran 1600P Specifications

General

Brand	gefran
Model	1600P
Category	Controller
Language	English