918070/FP0811 4-25 Printed in U.S.A.
Note: A grease gun is supplied with machine tool kit.
6. Start the engine. Lower the unit to the ground.
7. Repeat this procedure for the other track.
Figure 4-24 Track Adjustment
Do not over-tension the track. If track is too
tight, loosen the grease fitting to relieve
pressure.
Do not loosen grease fitting more than two
turns, or grease fitting could be ejected
under pressure and cause injury. Keep your
face and body away from the fitting when
loosening.
To Next Page
Loading...
