56
In case of spill, brine is not irritating, nor toxic and nor harmful, does not produce noxious fumes. It is
however recommended to avoid contact with eyes.
Never disassemble the components of the valve.
Check that during installation pipes are without any working shavings or any other foreign bodies.
Provide a power supply plug 230 Volt +/- 10% - 50/60 Hz.
For a proper working of the softener, do not make any extension on the power supply cable.
After installation, make sure that the unit does not stand on the power supply cable.
Place the vessel and the salt container close to each other, on a flat and solid surface, in a dry
room protected from frost and hygienically suitable, away from sunrays and atmospheric agents,
by taking care of leaving free rooms for maintenance.
Connect the brine suction hose between the container and the head (in the monobloc model it is
connected already; in Duplex models the hoses are two).
Install a filter (6) between the by-pass for the cutting out of the system and the water supply entry
of the softener.
For in-out connections of the softener to the system use flexible hoses or vibration-damping joints.
Model of softener Minimum flow rate at the entry during regeneration
(l/min)
Decalux 5 5,33
Decalux 10 5,33
Decal / Decalux 15 8,00
Decal / Decalux 20 8,00
Decal / Decalux 25 8,00
Decal / Decalux 30 8,00
Decal / Decalux 45 11,66
Decal / Decalux 60 15,83
Decal 75 15,83
Decal 110 24,16
Decal 110 M 24,16
Decal 140 24,16
Decal 140 M 24,16
Decal 200 24,16
Decal 200 M 24,16
Decal 200 B 96,64
Decal 250 M 24,16
Decal 250 B 96,64
Decal 320 B 150,00
Decal 500 B 200,00
To Next Page
Loading...
