34
In case of spill, brine is not irritating, nor toxic and nor harmful, does not produce noxious fumes. It is
however recommended to avoid contact with eyes.
• Never disassemble the components of the valve.
• Check that during installation pipes are without any working shavings or any other foreign bodies.
• Provide a power supply plug 230 Volt +/– 10% - 50/60 Hz.
• For a proper working of the softener, do not make any extension on the power supply cable.
• After installation, make sure that the unit does not stand on the power supply cable.
• Place the vessel and the salt tank close to each other, on a flat and solid surface, in a dry room
protected from frost and hygienically suitable, away from sunrays and atmospheric agents, by taking
care of leaving free rooms for maintenance.
• Connect the brine suction hose between the tank and the head (in the monobloc model it is connected
already).
• Install a filter (6) between the by-pass for the cutting out of the system and the water supply entry of
the softener.
• For in-out connections of the softener to the system use flexible hoses or vibration-damping joints.
• Connect the drain hose of the valve and the overflow hose of the
salt tank to the drain with two separate hoses.
IMPORTANT: The drain must be free (at atmospheric pressure)
and not sealed.
• Provide a siphon drain pipe with enough draining capacity (Ø 25
mm for models up to Decalux 25).
• The drain must be lower than the “overflow” level of the tank.
YES NO
V
V
X
X
NO
NO
YES
YES
To Next Page
Loading...
