What to do if my GEL DOSAMATIC PP display shows “ERROR MEM” or “ERROR DATA”?
If your GEL Water Pump display shows “ERROR MEM” or “ERROR DATA”, it indicates an issue with data. For “ERROR MEM”, reload the default values by following the “Load default” procedure at section 11.9. For “ERROR DATA”, check the entered data; if the errors persist, the pump may be undersized.
Why is my GEL Water Pump not dosing even though the magnet is giving impulses?
If your GEL Water Pump is not dosing but the magnet is giving impulses, it could be due to several reasons. First, check that the foot filter is not clogged by impurities and crystals. The suction hose might be empty, meaning the pump isn't primed, so repeat the priming procedure. Also, air bubbles might have formed in the hydraulic circuit, so check the hoses and fittings. Finally, the product being dosed might be producing gas; in this case, open the discharge tap to release the air or replace the pump body with a self-venting one.
What to do if GEL DOSAMATIC PP is not dosing and magnet is not giving impulses?
If your GEL Water Pump is not dosing, and the magnet isn't giving impulses or the stroke is cushioned a lot, it could be due to crystal formation blocking the balls. Try cleaning the valves and circulating 2-3 liters of water instead of the chemical. If that doesn't work, replace the valves. Another possibility is an obstructed injection valve, in which case you should replace the valve.
How to troubleshoot a GEL DOSAMATIC PP Water Pump that does not switch on?
If your GEL Water Pump does not switch on, first, check that the mains voltage corresponds to the voltage indicated on the rating plate of the pump. Also, check the fuse; if it's blown, replace the electronic card.
Describes the various parts of the diaphragm metering pumps.
Doses at a constant rate based on SPH, SPM, or LPH settings.
Impulses from water meter are divided by set value for dosing.
Impulses from water meter are multiplied by set value for dosing.
Dosing based on PPM value, product concentration, and quantity per stroke.
Dosing initiated by an external contact, programmed by strokes or quantity.
Dosing proportional to input voltage, based on min/max stroke rates.
Dosing proportional to input current, based on min/max stroke rates.
View dosing statistics like total doses and number of strokes.
Overview of pump settings including working mode, voltage, and flow rate.
Displays active alarms such as level, overflow, power, stroke, and batch.
Guidelines for correct pump installation by qualified personnel.
Steps to prepare for pump installation, including hydraulic and electrical connections.
Instructions for safe and correct electrical connections by qualified staff.
Procedures for initial pump startup and testing, including safety precautions.
Procedure to prime the pump without contact with the chemical.
Setting main parameters like cc/stroke and calibration for pump operation.
Setting up the water meter specifications for accurate dosing.
Setting maximum time between impulses for specific working modes.
Setting or resetting the pump's access password.
General| Brand | GEL |
|---|---|
| Model | DOSAMATIC PP |
| Category | Water Pump |
| Language | English |
To Next Page
