Flags are settings of the AX-150 and can change the way the machine works.
Please do not alter these without fully understanding the consequences of your
action. IMPORTANT If you are unsure please consult your dealer before making
any changes.
If in the unlikely event the ECR is in a “Lock up situation” i.e. not able to produce a
transaction or the machine is continuously bleeping then a „Half reset‟ initialisation
is required.
Turn the key to the ‘P’ position on the control lock and power off the ECR
for 30 Seconds. Power on the ECR and turn the key back to the ‘R’ position.
The error will be cleared.
IMPORTANT
A full system clear should only be carried out after careful consideration.
This procedure will completely clear all of the memory and sales data of the
ECR.
To Previous Page
Loading...
