To Next Page

To Previous Page

MULTIPEDAL MODE

The multipedal is a new optional accessory unit speciﬁ cally designed for Genesys. This unit has six pedal

switches. All six may be used with the simple connection of only one pedal input: leaving the remaining

two available for volume and sustain.

Press the [PRESET] button in SECTION EDIT

To access the MULTIPEDAL mode functions, the optional MUL-

TIPEDAL unit has to be connected to the Genesys.

NOTE:

In this example we assume the MULTIPEDAL is con-

nected to the input N. 1 on the rear panel. If you

have Connected the MULTIPEDAL to a

different

input, you will have to select the correct one.

Press the function button [B] or ENTER to enter

the menu

DAMPER, SOFT and SOSTENUTO can not be assigned to the

single switch pedal in MULTIPEDAL mode.

NOTE:

Select MULTIPEDAL in the pedal 1 ﬁ eld

Press the function button [F5] MULTIPEDAL 1

The display shows the MULTIPEDAL assign

screen

Select the function you want to recall with each

pedal by rotating the DIAL.

It is also possible to check the function assigned

to the pedal simply pressing the relative foot-

switch.

Select another footswitch by using the CURSOR,

then select the desired function with the data

DIAL.

Repeat the operation until the six footswitches

are assigned to the functions you wish them to

control.

Up to 3 MULTIPEDAL unit can be connected at the same time

to the Genesys pedal input

multipedal modePage6

release notes

Genesys series

GEM genesys xp Release Notes

Other manuals for GEM genesys xp