midifi le edit upgrade Page19
release notes Genesys series
TO CONFIRM THE EDITING PROCEDURE: STORE
The editing to the function just described (TRANSPOSE, VOLUME LEVEL, PAN, SOUND) can be executed in
the way and order you wish (i.e. only the TRANSPOSE, only VOLUME, etc.). The most important operation
at the end of each editing session is to fi x the editing in the midifi le, for this purpose have to be used the
STORE button (*).
1
Once your midifi le editing is completed, press
the STORE button on the panel (from any screen
you are located on).
2
A confi rm screen appears in the display, press
the ENTER button as request
This screen allows to assign a destination driver
(HD, Floppy) and a directory for the edited midifi le.
It is possible to create a new midifi le subfolder into
the main MIDIFILE folder using the NEW FOLDER
[G] command.
IMPORTANT NOTE: in order to save the modifi ed midifi le sound map in a correct way, take care before to
store the edited data, to disable the GENERALMIDI mode in EDIT MIDI MENU (set: GENERALMIDI [OFF]) .
CHANGE A SOUND IN A SEQUENCER TRACK IN GENESYS XP
The display shows the following screen
Genesys xp is the module version of the workstation, for this reason has a different control panel layout
and a different method to recall the single sounds in the sequencer tracks.
To enter in the single sounds selection menu: select any of the sequencer track, then press the SOUND
button in RESOURCE section.
The function buttons A-H
and F1-F8 select the sound
family (Sound bank).
the buttons from 1 to 8
in the RESOURCES area,
select the sound inside the
family (sound bank).
To Next Page
Loading...
Need help?
General
