14
Tune
The TUNE function allows you fine tune the instrument. The default
status of the instrument corresponds the equal standard A = 440 Hz,
shown in the display as the setting “00”. The TUNE value has a range
of
±
63, corresponding to an excursion of approximately one semitone.
1. Press and hold the TUNE function key (G7) and press either the TEMPO/
DATA + or the – button to raise or lower the tuning accordingly.
The first time you press the TEMPO/DATA + or – button, the 3 digit
LCD display will show the current setting (00) and you will hear a
sinusoidal reference note A play at the standard pitch.
To raise the tuning
2. While still holding down the TUNE function key (G7), press the TEMPO/
DATA + button repeatedly until you obtain the required tuning.
The LCD display will show the current setting and the reference
sinusoidal sound will play with the current tuned pitch.
Release the TUNE function key (G7) to escape the function.
To lower the tuning
3. While holding down the TUNE function key (G7), press the TEMPO/DATA
– button repeatedly until you obtain the required tuning.
The LCD display will show the current setting and the reference
sinusoidal sound will play with the current tuned pitch.
Release the TUNE function key (G7) to escape the function.
The current Tune setting will remain memorized even after turning
the instrument off.
To reset the tuning
4. Hold down the TUNE function key (G7) and press both the TEMPO/DATA
+/– buttons at the same time.
The LCD display will show the standard setting and the reference
sinusoidal sound will play with the standard pitch (C = C).
To Next Page
Loading...
Need help?
General
