GEM RP80 User Manual

3
7. T OUCH : Use this button to adjust the touch of the keyboard according to your playing style.
8. B ALANCE / : These buttons regulate the volume balance between two sounds in either Layer or Split
modes.
9. D ISPLAY : A three-digit, LCD display.
10. T EMPO D ATA +/–: Use these buttons to modify the playing speed (Tempo) when using the Sequencer and to
select Songs from the Song Library when the Song Library button is active.
In Function mode, the Data buttons change the parameter status of the current function. The
functions are selected with the last four notes of the highest octave of the keyboard.
11. R ECORDING S TUDIO : This section contains functions that control the on-board Sequencer.
Play\Stop : Press this button to playback what you have recorded, to stop the playback or
stop the recording.
Rec. : Press this button to record what you play.
Click. : Press this button to record or playback with or without the click of a Metronome.
Song Library. : Press this button to gain access to the internal Song Library consisting of
96 famous pieces of piano music, useful to practice with as well as listen to.
12. P OWER O N /O FF : Press to turn the instrument on and off.
13. H EADPHONES : Two Headphone jacks to connect headphones.
14. F UNCTION KEYS : Notes G7-C8 of the highest octave are dedicated to the selection of the RP80 functions. The
function parameters are selected with the Data +/– buttons while holding down a function key.
Rear panel
21
3
4 5
1. P EDALS : The pedal group consisting of two pedals (Soft and Damper) should be plugged into this
connector.
2. MIDI I N /O UT : These ports allow the instrument to be connected to other MIDI devices.
3. I NPUT : You can use these two inputs to connect another instrument to the RP80. The output of the
other instrument will be mixed with the main signal of the RP80 and sent to the Output,
Speaker and Headphone jacks. If you are connecting a mono signal, then you should use
only the Right/Mono jack.
4. O UTPUT : These two stereo outputs are used to connect the instrument to another amplifier, mixer or
recording device. If you are connecting to mono equipment, (e.g. a guitar amplifier), then you
should use only the Right/Mono jack.
5. M AINS INPUT : Connect the supplied power cord to the mains socket and the other end to a suitable wall
outlet. Make sure that the mains supply matches the voltage indicated on the instrument’s
identification tag.

GEM RP80 Specifications

General

Brand	GEM
Model	RP80
Category	Musical Instrument
Language	English