Turning on and off Charging
Power on
• Push button once to turn on Blue-
tooth connectivity.
Power off
• Push button and hold for 6 seconds
to turn off device.
• In Bluetooth mode, remove the card
to turn off device.
Wake up
• Device will go into deep sleep/power
saving mode after 4 minutes of no
connection or operation. Push pri-
mary button to turn back on.
Charging through USB
• Battery charges fully in 3 hours.
• Bluetooth Smart wireless interface
can be activated when charging
through USB by pressing the button.
• Please note that USB connectivity
will not be available during a Blue-
tooth session.
Charging with external power
• Bluetooth Smart wireless interface
will still be active when charging on
USB external power adaptor.
Battery life
• Typical battery duration is 3 weeks
(continuous 10 hour login and 5 PKI
operations a day).
Modes
Battery
• Ensure battery is properly charged
Software
• Check Gemalto software package is in-
stalled correctly
Initiate pairing
• Press primary button for 3 seconds to set
badge holder into pairing mode. The LED
will blink quickly
• Once pairing communication has started,
the badge holder switches to non-
discoverable mode, and is not visible to
any other master
• If pairing is not confi rmed within 4 min-
utes, the badge holder goes back to deep
sleep mode and disconnects.
• Note: Windows 10 ONLY, the CT1100 must
be paired with Windows prior to pairing
with the Gemalto GUI.
Quick start
Pairing Complete
• The badge holder can record up to 10
different paired master devices. If list of
paired devices is full when trying to pair
with a new device, the master in that list
that was connected the longest time ago
will be removed
Detection Range
• The badge holder disconnects and enters
deep sleep mode if moved away out of
device detection range.
To Next Page
Loading...
Need help?
General
