4- Once clean, rinse the cell immediately with freshwater, dry the terminal area
properly and reinstall it in the housing.
Do not leave the cell in the acid solution for longer than 5 min. Do not
scratch the electrodes with metal objects. For safety reasons, always add
the acid into the water!
2- Recommendations
The bipolar cells of GSC Salt-Water chlorinator are manufactured using an
special technique with high quality standards, conferring them extraordinary
duration and resistance. However, there are several factors that may reduce the
best and longest performance of your chlorinator.
These are:
- Operating with lime residue on the surface of electrodes
- Excessive chlorine concentration (chlorine is corrosive above 3.0 ppm)
- pH too low or too high
- Absence or very high concentration of salt
- Water temperature below 10°C,
- Adding the salt when the chlorinator is working,
- pH corrector injection before the housing, in the skimmers or on the
bottom drain inlet
We recommend you periodically check the cell terminals and oiling them for
avoid sulphating.
Turn the equipment off whenever:
- No water circulates
- While cleaning the filter
- While the pool is being emptied
- The water is frozen
- While cleaning the cell
3- Technical Characteristics
Recommended
Salt Concentration
Warranty, After-Sales Service And Spare Parts
1. The electrolytic cell and the rectifier will be guaranteed for 2
years.
2. The Products are out of warraty cover in the below cases.
a. If the instructions in this manual are not followed
b. Errors in electrical connections
c. Accidental damage
d. Damage due to water in the rectifier
To Next Page
Loading...
Need help?
General
