To Next PageTo Next Page
Need help?Do you have a question about the Gemini 933MHW and is the answer not in the manual?
General| Brand | Gemini |
|---|---|
| Model | 933MHW |
| Category | Security System |
| Language | English |
Description of buttons 1, 2, and 3 on the remote control for system operation.
Step-by-step instructions for replacing the remote control battery, including warnings.
How to arm the system using the remote control, confirmed by siren and turn signals.
Arming the system while excluding interior protection sensors via remote control.
Automatic system arming 60 seconds after ignition off and last door closed.
A 30-second delay period after arming before the system is fully active.
Confirmation that the system is fully armed after the delay period.
Details alarm signaling, time intervals between alarms, and alarm cycle durations.
How to disarm the system and what signals indicate a previous alarm event.
Method to identify the last alarm event using LED flashes upon disarming.
Detailed table listing wire functions and colors for the 20-pin connector.
Detailed table listing wire functions and colors for the 8-pin connector.
Schematic illustrating the main connections for the alarm system.
Guidance on connecting wires for turn indicator signals.
Explains how to configure the system for specific vehicle models.
Step-by-step guide on how to input and confirm vehicle codes.
How the system operates using the vehicle's CAN BUS line for arming/disarming.
How to arm/disarm the system and control vehicle doors using the Gemini remote.
Table detailing programmable functions, their status, and LED flashes.
Activating optical signals (turn indicator flashes) for system arming/disarming.
Activating acoustic signals (siren chirps) for system arming/disarming.
Configuration for passive arming mode, including interruption logic.
Modifying the alarm input signal based on door switch polarity.
Enabling double pulse unlock for simultaneous door unlocking.
Steps to enter programming mode using the Gemini remote control.
How to enable or disable programmable functions using remote buttons.
Ensuring correct electrical connections and understanding memory limits.
Procedure to activate learn mode using ignition and bonnet switch.
Steps to pair remote controls or other devices with the system.
Ensuring correct electrical connections before initiating deletion.
Procedure to activate deletion mode using ignition and bonnet switch.
How to clear all programmed devices from the system memory.
Instructions for connecting and positioning the ultrasonic sensor cells.
Procedure to check and adjust the sensor sensitivity level.
Steps to reset the system to its factory default state.
