Need help?Do you have a question about the Gemini GEM-P801 and is the answer not in the manual?
General| Brand | Gemini |
|---|---|
| Model | GEM-P801 |
| Category | Security System |
| Language | English |
Electrical specifications including voltage, current limits, and output ratings.
Details on loop voltage, current, and resistance for the panel zones.
Information on keypad limits, receiver capacity, and wire length.
Requirements for power transformer and battery backup.
Physical dimensions, shipping weight, and operating temperature.
List of smoke detectors approved by UL for use with the GEM-P801.
Compliance with UL, CSFM, and FCC standards.
Part numbers for the panel, keypads, and accessories.
Steps to reset the panel to factory default settings.
Reference to instructions for programming via keypad.
Overview of local and remote downloading capabilities.
Guidelines for physically installing the control panel and keypads.
Instructions for grounding, power, and telephone line connections.
Recommendations for installing smoke detectors and heat detectors.
Procedures for wiring burglary and fire zones with EOL resistors.
Details on PGM output wiring and keypad connections.
Explains keypad LEDs, sounder feedback, and basic operation.
Meanings of various LEDs on the keypad.
Procedures for arming, disarming, and using instant mode.
Managing alarms, bypassing zones, and automatic bypass functions.
Entering and using the user programming mode.
Example of programming user codes.
List of commands for panel functions like Bell Test, Chime, etc.
Accessing PGM output and performing downloads.
Checking and logging wireless transmitter signal strength.
Retrieving stored signal strength information.
Explains various zone types like Exit/Entry, Home/Away, etc.
Details on disabling EOL resistors and output settings.
Configuring exit/entry delays, test timers, and supervisory timers.
Configuring keypad functions, panics, and displays.
Settings for abort delay, easy exit, swinger shutdown, and PGM activation.
Assigning PGM outputs for various alarm and system events.
Programming subscriber ID, phone number, and receiver format.
Defining zone and system reports for the primary phone line.
Setting up the secondary phone line for reporting.
Configuring dialing prefixes and communicator modes.
Setting up pager formats, leading/trailing digits, and options.
Configuration for a third telephone number.
Explains zone, system, and event report codes.
Mapping wireless devices and configuring keyfob functions.
Assigning functions like Panic, AUX, or Bell ON to keyfob buttons.
Configuring keyfob operations and wireless smoke detector supervision.
Settings for callback numbers, ring counts, and download features.
Steps for automated downloads via PC-Preset.
Setting dealer code, user lockout, and system options.
Notes regarding programming blocks [96] and [97] on panel default.
Setting the number of re-dial attempts for communication failures.
Method to access and interpret system trouble codes.
Pulse and Point ID codes for various system troubles.
Detailed table of system troubles, their causes, and actions.
Addresses issues with bell output voltage, supervision, and short circuits.
How to remove keypad sounder on alarm and activate zone chime.
Information on PGM output pulsing and internal over-current protection.
Disabling keypad sounder for entry time and chime.
Diagnosing transmitter response and keypad LED flicker.
Visual guide for connecting system components.
Important notes regarding wiring practices and component compatibility.
Terms and conditions of the product warranty.
Required FCC statement regarding radio frequency energy and interference.
To Next Page
