Gemini DS-2024 - Sample Playback Modes; Microphone Sampling; Robo Playback Functionality

SAMPLE PLAYBACK MIC SAMPLING
1. Select the memory bank you wish to play by 1. To make a sample from the microphone, push the
pushing the appropriate MEMORY BANK (22)
button.
. Tapping the START/STOP (2) button with the
MODE SELECTOR (4) switch in the SINGLE
position will cause the sampler to playback one
time (the SAMPLER INDICATOR (26) will
illuminate GREEN). Every push of the START/
STOP (2) button will restart the sample from the
beginning. Rapid pressing of the START/STOP
(2) button will cause a stuttering effect. Once the
sample has started playback and the START
{STOP (2) button is not pushed a second time,
the sample will play to the end and then stop (the
SAMPLER INDICATOR (26) will turn off).
. Tapping the START/STOP (2) button with the
MODE SELECTOR (4) switch in the REPEAT
position, will cause the sample to continually play
over and over (the SAMPLER INDICATOR (26)
will illuminate GREEN). The START/STOP (2)
button will act as an on/off switch. The first push
will start the sample, the second push wil! stop
the sample.
SAMPLER MIC (10) button (the MIC SAMPLE
INDICATOR (27) will illuminate RED). The
microphone signal will now be the only signal
going to the sampler. The selected source will still
play through the unit but it cannot be sampled.
The microphone output is controlled by the
microphone section of ypur mixer.
ROBO PLAY™
1. With the ROBO PLAY™ (9) button in the
OFF position (the ROBO PLAY™ INDICATOR
(28) will be off), the SOURCE SELECTOR
(11) switch NOT in the OFF position and
the MODE SELECTOR (4) switch in either
SINGLE or REPEAT, the sample will play
along with the selected source.
. When the ROBO PLAY'™ (9) button is ON
(the ROBO PLAY™ INDICATOR (28)} illuminates
RED), starting the sampler mutes the selected
source. When the sample ends, the source
automatically turns back on.