- 12 -
Pre-installation Checklist in Windows
Hardware and software requirements:
To run this software, your must have the hardware and software described
below. Check your system before you begin the installation.
Operating System Windows 98(including second edition), 2000 Professional,
Me and Xp
CPU Pentium 233MHz or higher
RAM 32MB RAM or higher
Accessory USB port
Hard Disk Space 200MB free hard disk space
Note:
- Connect the PC and the digital camera directly using the USB
cable. Connecting via USB hub is not guaranteed.
- USB interface board is not guaranteed.
- Self-made PC is not guaranteed.
Installation on Windows PC
The J44416 includes the following software and applications: Camera driver -
to provide image transfer from the camera to your computer, Ulead Photo
Express 4.0 SE – for photo editing and Adobe Acrobat Reader - to access the
Owner’s Manual (PDF).
Installing the Camera driver – J44416
Insert the J44416 CD into your CD-ROM drive. The CD should auto run.
Otherwise, go to Start Æ Run and type “D:\autorun.exe” (where D:\ is your
CD-ROM drive). The following screen will appear on your monitor.
1. Press the “Digital Camera driver”
2. Press “Yes” to agree the license agreement and
then start the J44416 driver installation.
3. The usable file transfer to the computer.
4. The installation complete. The windows ask for
restart the computer to activate the driver. Press
“Yes” to restart now or Press “No” to restart later.
To Next Page
Loading...
Need help?
General