Need help?Do you have a question about the GemOro AuRACLE AGT1 and is the answer not in the manual?
General| Brand | GemOro |
|---|---|
| Model | AuRACLE AGT1 |
| Category | Test Equipment |
| Language | English |
The AGT1 exclusively tests the surface of metal objects.
Optimal temperature, dry, and clean metal surfaces ensure accurate testing.
Identifies gold karats, platinum, non-gold materials with an LED bar graph.
Labels and descriptions of the AGT1's various parts and indicators.
Details working voltage, warm-up time, temperature, humidity, and weight.
Provides a link for video demonstrations of the AGT1.
Instructions for installing the 9V battery and powering on the device.
How to connect the pen probe and handle initial solution.
Emphasizes mandatory calibration before first use and each power-on.
Detailed steps for calibrating the AGT1 using a 14K gold standard.
Explains why recalibration is needed due to chemical changes affecting probe accuracy.
Crucial step to file metal surfaces to avoid misrepresentation from plating.
Advises using common sense for final determination of karat or authenticity.
Check karat stamps; results below 10K or contrary to stamps are suspect.
Pieces testing as 'NA' are confirmed as not gold.
Suspect pieces that seem too light should be checked, as gold is dense.
Be wary of overly yellow gold or variations indicating plating or fake.
Examine clasps; spring ring clasps may indicate costume jewelry.
Steps to place metal on the plate and touch the filed area with the probe.
Notes on potential inconsistencies in testing gold above 18K due to alloy variations.
How platinum is indicated, and potential readings due to rhodium plating.
Protect the instrument, replace probe cap, and clean the probe tip.
Identifies the REPLACE BATTERY light and procedure for replacement.
Identifies the REPLACE PROBE light and when to replace the probe.
Tips on battery replacement, AC adapter use, and limitations of the tester.
Addresses warm-up time, excess solution, and probe issues.
Covers calibration requirements and issues with the REPLACE PROBE light.
Details probe contact pressure and avoiding excessive force during testing.
Instructions for cleaning the probe tip and managing contaminants.
Always use plumb 14K yellow gold for calibration and ensure the probe tip is clean.
Outlines the one-year limited warranty for materials and workmanship.
States compliance with EU directives and safety standards.
Provides additional technical details and environmental conditions.
To Next Page
