3 AuRACLE Gold Tester
CONDITIONS FOR IDEAL OPERATION:
The AuRACLE AGT1 must be used in the following
environmental conditions. By not following these
instructions you risk compromising the accuracy of
the test.
A. Temperature: The AGT1 is a workhorse and
is capable of working in most any normal or
professional environment, with room temperature
of approximately 65-75F being the best. While
it has proven to work just fine in temperatures
as high as 100F, ideally it is suggested to avoid
using the AGT1 in extreme temperatures. The
metal being tested must be dry. If the surface
of the metal is wet or has any type of surface
moisture it may not test correctly. The metal
being tested must be clean of any obvious dirt or
contaminant that might interfere with the contact
of the pen probe to the metal. The tester may
be used otherwise with little concern for normal
surface dirt or hand oil and will work perfectly. It
is imperative that the pen probe tip be cleaned
from time to time, especially when it visibly
appears dirty or encrusted with a white granular
salt residue. This will enhance its usage life and
improve its accuracy.
B. The metal being tested must be dry. If the surface
of the metal is wet or has any type of surface
moisture it may not test correctly.
C. The metal being tested must be clean of any
obvious dirt or contaminant that might interfere
with the contact of the pen probe to the metal.
The tester may be used otherwise with little
To Next Page
Loading...
